LESSON 18
- “干涉”怎么说?
- “运转”怎么说?
- bifa·必发(唯一)中国官方网站:“工序切换”怎么说?
- bifa·必发(唯一)中国官方网站:冷却水流量下降造成装置故障!
- bifa·必发(唯一)中国官方网站:如何防止过滤装置堵塞?
- “波形”怎么说?
- bifa·必发(唯一)中国官方网站:有关建议的表达方法
- “加工”怎么说?
- “配线”怎么说?
- 有关电气破坏
“加工”用英语怎么说?
加工一般用“processing”来表示。

- The cost for processing the new product is more than we expected. We need to do something about it but I don't know where to start.
- 新产品的加工费超出了计划。必须要采取一些措施,但不知道从何做起。

- Is there any special processing machines being used or any part of the process being outsourced? Or maybe there is some part of the process taking longer than planned?
- 是否使用了特殊装置,或者有外包加工的工序?
还是说有超出计划加工时间的工序?

- Come to think of it, they said the changeover for each size takes longer than usual since a high processing accuracy is required for the new product.
- 我想起来他们说,由于新产品需要很高的加工精度,
因此每种尺寸的转换时间都比平常要长。

- Then you may want to consider making better use of fixtures or see if you could do the changeover outside of the processing time.
- 那么,试着研究一下夹具改良或可以在非加工时间内进行工序切换
怎么样?
将使用“加工”的表达方法总结起来记住的话,会非常方便。
- ・加工时间“processing time”
- ・加工精度“processing accuracy”
- ・加工费“processing cost”
- ・加工顺序“sequence of processing”